...

1. Add the public key for the Partek package repository*
   $ sudo apt-key adv --keyserver keys.gnupg.net --recv-keys C82B61BF
   
   
2. Add the Partek package list to your repository*
   $ sudo wget -P /etc/apt/sources.list.d/ http://packages.partek.com/debian/partek-flow.list
   *Steps 1 and 2 only need to be performed once prior to the first installation. Re-installation and updates do not require this step.
   
   
3. Update the list of available packages
   $ sudo apt-get update
   
   

4. Install Partek Flow
   $ sudo apt-get install partekflow
   When asked to continue, type the letter Y and press Enter.
   During the installation, you will be prompted for the Flow server port (Figure 1). Unless necessary, accept the default HTTP port: 8080 by pressing Enter.
   
   

   Numbered figure captions
   SubtitleText Configuring HTTP port for Partek Flow during installation AnchorName HTTP Port Configuration
   Image Modified

   
   

5. If additional configuration is needed, use the reconfigure command below. This can be run any time after Partek Flow is installed. For details regarding each setting, contact the Partek Licensing Department. In most cases, this step can be skipped.
   $ sudo dpkg-reconfigure partekflow
   
   
6. (Optional) To manually configure Partek Flow or to set additional advanced options or environment variables, edit the following configuration file:
   /etc/partekflow.conf
   Note that all changes made by the reconfigure command in step 5 are also stored in this configuration file.
   
   
7. Start the Partek Flow server
   $ sudo service partekflowd start
   A message should indicate that Partek Flow is now running:Starting Partek Flow server: OK
   Step 7 needs to be performed only once after installation. Partek Flow will start automatically whenever the server restarts.

...